Skyline Panel Loveseat Recliner shown in Quarter Sawn Oak. Pick your stain. Each seat reclines while footrest pops out by pushing back in chair.
Dimensions: 62 1/2"w x 38 1/2"d x 40"h
Pick your fabric from fabric samples in upper left. Leather is an upcharge.
Our consumer protection is our promise to you, the original purchaser, that each of our products will be free from manufacturing defects for its useful life, provided the furniture is used in a residential application.
FRAMES AND SPRINGS:
Our furniture warrants to you, the original retail purchaser, lifetime protection against manufacturing defects of frames and springs.
RECLINER MECHANISMS: (250lb load rating)
Our furniture warrants to you, the original purchaser, a limited three (3) year warranty for residential use only. In the even a mechanism is determined by us to be defective within the warranty period, we will, at our discretion, repair or replace the mechanism.
In no event shall we be responsible for any disassembly, installation, or labor charges outside of our manufacturing facility. In addition, we shall not be responsible for any shipping or packing charges, except during the first year of this warranty.
GLIDER BEARINGS: (250lb load rating)
We warrant to you, the original retail purchaser, a two (2) year warranty. If found defective, we will replace the defective bearing or bearings. In no event shall we be responsible for any disassembly, installation or other charges outside of our manufacturing facility.
We fabricate our standard seating with (F2.7 35lb density) seating foam, which is a very high quality foam used in the upholstered furniture industry. We warrant to you, the original retail purchaser, a limited lifetime warranty on our (F2.7 35lb) foam cores against manufacturing defects.
Even though we use a high performing polyurethane foam, some flattening or loss of resiliency will occur as a result of normal use and aging. This is not covered under the warranty.
Cushion materials conform to the shape or the user and is not considered to be manufacturing defect.
Cushion softness is significantly affected by the type of fabric or leather that surrounds it. Proper maintenance and seat cushion rotation where applicable will provide longer life and greater durability.
Cushions suspected to be defective must be returned to the builder for industry testing. If it is determined that the cores were not properly cared for or were under extreme abuse, the warranty would be void. If found defective, we will replace at no charge. Shipping and handling charges will apply to cushion cores replaces after two (2) years.
Most back cushions are constructed with (F1.5 12lb density) foam cores. These will be covered under the same guidelines as our seat cushion warranty policy.
This product was added to our catalog on Saturday 16 April, 2011.